Expenses:
$0.00
Hours:
25.00
Jan 23, 2023
Many hours were spend on wiring sensors, crimping, splicing, and re-doing the whole power bus just to make sure most of the breakers still fit in the original place rather than make a bunch of holes in the panel. Added an Avionics Master switch.
Everything ringed out, power and ground is good. Power-on successfull (after getting a better power source, rather than a trickle charger) and getting the settings put in. At this point......it might not take much longer .....
Everything ringed out, power and ground is good. Power-on successfull (after getting a better power source, rather than a trickle charger) and getting the settings put in. At this point......it might not take much longer .....

RV-8
STOL CH 701
Glasair II
RV-7/9
RV-7/9
Baron 55
Baron 55
RV-8
150
Glasair II
RV-8
RV-7/9
Baron 55
T210N
Model 5/7
RV-8
RV-8
RV-8
RV-8
RV-8
RV-8
Baron 55
RV-7/9
172
172
172
Model 4
Model 4
Model 4
208
RV-10
S35 (no glovebox)
S35 (no glovebox)
RV-10
RV-10
T210N