Hangar Debrief
An email newsletter for builders, pilots and maintainers of experimental, light-sport and general aviation aircraft.
Past issuesSponsor Hangar Debrief
6 articles tagged Lycoming

Directives & Bulletins
AD 2026-22-13 replaces the Lycoming piston pin AD and adds the O-320, IO-320 and O-435 families
AD 2026-22-13, effective November 24, 2026, replaces AD 2026-17-10. It adds the O-320, IO-320 family and O-435 family to the O-235, O-540 and IO-540, with no serial number list. A listed engine with P/N LW-13445 piston pins made January 7, 2021, to December 15, 2025, or of unknown date, needs an oil and screen check within 5 hours and new pins.
6 Nov 2026

Directives & Bulletins
NTSB Safety Alert SA-109: sticking exhaust valves, 42 accidents from 2015 to 2025
NTSB Safety Alert SA-109 of Oct. 29 counts 42 accidents from 2015 to 2025 in which a stuck valve cost power; five people died. A Zenith CH 750 STOL is among its examples. The signs are a rough engine, worst when cold, and one cylinder's EGT or CHT out of line. Owners should keep oil and filter intervals and lean correctly; mechanics should keep baffles sound.
4 Nov 2026

Directives & Bulletins
Lycoming SB 639A: rocker arm inspection on the O-320-H2AD and the O-360-E1A6D family, revised October 8, 2026
Lycoming Mandatory Service Bulletin 639A, dated October 8, 2026, revises the rocker arm (P/N LW-15014) inspection for O-320-H2AD and O-, LO-, TO- and LTO-360-E1A6D engines shipped from Lycoming since June 2017 with under 500 hours. The first inspection, at the next scheduled oil change, now takes out the rocker arms and the hydraulic lifters; a visual check follows every 50 hours until 500 hours.
29 Oct 2026

Upgrade & Maintain
Preheating a piston engine in cold weather: Lycoming's 10°F line, hot air and installed heaters
Lycoming Service Instruction 1505 requires preheat when a Lycoming engine has cooled below 10°F (20°F for -76 series engines such as the O-320-H and O/LO-360-E). An owner can preheat with a high-volume hot-air heater, following the instruction's steps, or install an electric system such as Hartzell Preheat's Tanis or Reiff heaters. A heated dipstick alone is not approved.
27 Oct 2026

Directives & Bulletins
AD 2026-17-10: oil check and new piston pins for certain Lycoming O-235, O-540 and IO-540 engines
AD 2026-17-10, effective September 14, 2026, covers Lycoming O-235, O-540 and IO-540 engines listed by serial number in Lycoming MSB 667A that have P/N LW-13445 piston pins with a production date of January 7, 2021, to December 15, 2025. It requires an oil change and a filter and screen inspection for metal, then replacement of the pins. The FAA counts 957 engines on U.S.-registered airplanes.
21 Oct 2026

Directives & Bulletins
AD 2026-04-11: Lycoming connecting-rod bushing inspection, and whether it applies to amateur-built aircraft
AD 2026-04-11 expands the Lycoming connecting-rod bushing directive to engines assembled through September 2021. Its wording reaches only engines in type-certificated aircraft, so it doesn't legally bind an amateur-built. The FAA cites connecting-rod failures that led to uncontained engine failures and in-flight shutdowns; the first required step is an oil-filter inspection at each oil change.
11 Oct 2026